1. Structural composition 　　Electronic valve: It is composed of an electronic electric actuator and an electric regulating butterfly valve through mechanical connection, after installation and debugging.

    　　 Pneumatic valve: intelligent display instrument, control system.  Hardware composition: 1 computer, 1 set of PLC (including CPU, I/O module, ID212, OC224, AD003 module), 2 relays, 2 solenoid valves, 1 pneumatic valve actuator.

    　　2, valve style 　　 electronic valve: 　　 butterfly plate adopts frame structure, high strength, large flow area, small flow resistance; the overall baking paint can effectively prevent corrosion, only need to replace the sealing valve seat sealing material, it can be used for different media.

    Pneumatic valve: 　　
(1) Pneumatic V-shaped regulating ball valve
(2) Pneumatic O-shaped cut-off ball valve
(3) Torque cylinder ball valve
(4) Electromagnetic diaphragm valve
(5) Pneumatic straight-stroke diaphragm valve
3. Product features Electronic valve: 　　
(1  )Stainless steel and nitrile oil-resistant rubber are selected for the sealing pair, which has a long service life.

    　　(2) The rubber sealing ring can be located on the valve body or on the butterfly plate, which can be applied to different characteristics of media for users to choose.

    　　(3) The butterfly plate adopts a frame structure, with high strength, large flow area and small flow resistance.

    　　(4) The overall baking varnish can effectively prevent corrosion and can be used for different media as long as the sealing material of the sealing valve seat is replaced.

    　　(5) This valve has a two-way sealing function. It is not controlled by the flow direction of the medium during installation and is not affected by the spatial position. It can be installed in any direction.

    　　 Pneumatic valve: 　　 (1) The material of the valve body should be mainly ductile iron, and the grade and actual physical and chemical test data of the cast iron should be indicated.

    　　(2) Stem material, strive for stainless steel stem (2CR13), large diameter valve should also be stainless steel embedded stem.

    　　(3) The nut is made of cast aluminum brass or cast aluminum bronze, and its hardness and strength are greater than the valve stem.

    　　(4) The material of the valve stem bushing should not be greater than the valve stem in hardness and strength, and will not form electrochemical corrosion with the valve stem and valve body under water immersion conditions.